This page describes a laser cutting setting published for Vinyle adhésif sans PVC at 1 mm, tested on a Two Trees Totem S fitted with a Diode 5.5W source (445 nm blue diode, 5 W). It states the exact machine, source, material, thickness and operation of the test; power, speed and number of passes are shown with a Premium pass.
Why those four facts matter: a cutting setting that works on Vinyle adhésif sans PVC at 1 mm does not transfer to another thickness, nor to another source. A 445 nm blue diode rated 5 W does not deposit the same energy as a stronger module, and the speed has to be adjusted accordingly. Copying a number without checking those four points is the first cause of a ruined part.
Published by LaserSettings (estimation). No other workshop has confirmed it yet: treat it as a starting point, and confirm it from your account if you reproduce it.
No photo comes with this setting yet. If you reproduce it, publish yours from your account: a picture of the result is worth more than a line of numbers.
Recommended routine before running the part: clean the lens, redo the focus, engrave a small test grid on an offcut of the same Vinyle adhésif sans PVC, then adjust the speed rather than the power. Work with fume extraction and air assist, wear glasses rated for 445 nm blue diode, and never leave the machine unattended.
Two Trees offers compact diode engravers and enclosed models with an aggressive power-to-price ratio. Frame rigidity is the limiting factor: beyond a certain speed, vibration shows in the engraving before power becomes the problem.
PVC-free adhesive films (polypropylene or polyester) let you cut stickers and stencils with a laser safely. The word "vinyl" on the label is not enough: you need the "PVC-free" statement.
The whole point is the kiss-cut: through the film and its adhesive without cutting the backing paper. That needs a very fine setting, found with a rising-power test grid on an offcut.
Work at high speed and minimum power. The film is thin: a few percent too much power and the backing is cut through.
Molten adhesive can redeposit on the edge: high speed and air assist markedly reduce that tackiness.
A PVC-free film releases no chlorine, but burnt adhesive smokes and smells strongly: extraction needed. The backing paper ignites easily if power is too high.
Never run an unknown film, even sold as "cutting vinyl": most sign-making vinyls are PVC.
After cutting, let the sheet cool before peeling the stickers, otherwise the still-warm adhesive stays on the backing.