Every AlgoLaser machine is listed with its laser sources: wattage changes everything, a 10 W diode and a 40 W diode do not cut the same plywood. Alpha 10W (Diode 10W): 81 settings · Alpha 22W (Diode 22W): 80 settings · Alpha MK2 20W (Diode 20W): 84 settings · Alpha MK2 40W (Diode 40W): 84 settings · Delta 22W (Diode 22W): 84 settings · Delta 40W (Diode 40W): 84 settings · DIY Kit 10W (Diode 10W): 82 settings · DIY Kit 5W (Diode 5W): 83 settings.
In total 662 settings are published for this brand across 8 laser sources: for each machine, source, material and thickness combination you get power in percent, speed in mm/min, a pass count and whether air assist is needed.
A setting is a starting point, not an absolute truth: the lens, mirror cleanliness, the exact wood species and humidity all move the result. Run a small test square on an offcut of the same board first, then adjust speed before power — speed is the forgiving one.
If your AlgoLaser machine is missing, you can request it: the catalogue watch checks the brand's new releases every week and settings are generated as soon as a model is referenced.