Every Snapmaker machine is listed with its laser sources: wattage changes everything, a 10 W diode and a 40 W diode do not cut the same plywood. 2.0 A250T (Diode 1.6W): 82 settings · 2.0 A350T (Diode 1.6W): 83 settings · Artisan 3-in-1 (Diode 10W): 84 settings · Artisan 3-in-1 3D Printer (Diode 10W): 84 settings · Ray 20W (Diode 20W): 80 settings · Ray 40W (Diode 40W): 81 settings.
In total 494 settings are published for this brand across 6 laser sources: for each machine, source, material and thickness combination you get power in percent, speed in mm/min, a pass count and whether air assist is needed.
A setting is a starting point, not an absolute truth: the lens, mirror cleanliness, the exact wood species and humidity all move the result. Run a small test square on an offcut of the same board first, then adjust speed before power — speed is the forgiving one.
If your Snapmaker machine is missing, you can request it: the catalogue watch checks the brand's new releases every week and settings are generated as soon as a model is referenced.